Mounting A Wall Hung Sink On A Steel Stud Wall

The sink should be anchored to two wall studs.

Mounting a wall hung sink on a steel stud wall.

Install the threaded inserts to hold the bolts in place. Slip the sink over the mounting bolts and finger tighten the mounting nuts over the washers. Follow the manufacturer s instructions to mount the wall mount bathroom sink. Some sinks will require the use of a mounting bracket.

Smear pipe dope onto the threads of the supply line compression fittings and tighten them onto the faucet supply lines. Measure the sink installation height again and draw a mark using the level. Manufacturer number size name dimensions a c f rim height. Standard adjustable sleeve is 4.

Use a level to make sure the mounting bolts are level. Place the mounting plate in the installation location and mark the wall through each of the mounting holes. Then repair the drywall see how to repair drywall. Remove the plasterboard from the studs and insert noggins so that the supporting bolts can be screwed directly into them at the 2 locations previously marked.

1 position the sink or its mounting plate if it has one on the wall and mark the wall through the holes in the plate or sink. Josam 17125 series wall mounted single lavatory carrier. Insert the mounting bolts. To do this bridge the studs with a stud or track cut so that it s equal to the length of the wall.

Remove the 2 x 10 from the wall and drill 1 2 inch holes through the layout marks. Holding this cut stud or track in position with the web facing out mark the top and bottom flanges where they intersect with the wall stud flanges. Hold the mounting bracket against the wall at the proper height and drill a pilot hole into the wall studs. Fasten the 2 x 10 brace to the wall studs by using 2 1 2 inch screws.

Based on a dim shown. If there is no mounting plate use the holes in the back of the sink basin as your template. More often than not a pedestal sink s mounting holes will not line up with existing wall studs. Toenail the blocking to the studs with 3 1 2 inch galvanized common nails or screw it with 3 inch decking screws.

When your walls lack the studs to accommodate a pedestal sink you must use toggle bolts and. Measuring off the top of the basin note the position of the 2 x supporting bolt holes on the back and transfer these marks onto the wall centring the basin in its intended location. Mount the sink to the wall.