Nail Roof Flashing

These solid copper nails are the type recommended for use with many major brands of tile and slate roofing and are the most compatible nails for use with copper flashing the full 3 8 head gives good bearing pressure on roofing and flashing material.

Nail roof flashing.

Renew flashing seals by chipping out old caulking and mortar along the edges of the flashing. Hammer one nail to the. Re shingle roof valleys install ice and water shield under shingles or install metal roof flashing and re shingle the valley. Ensure it sits flat and extends at least 8 inches above the shingles.

Recaulk the joints between the roof and the flashing. If shingles get lifted or torn from high winds the damaged shingle exposes. Nail it in place with two nails one. Most flashing is 8 inches wide.

Bend it back so that it overlaps the corner flashing. Roof nail leaks can happen when roof nails have been loosened slightly from high winds or have simply pulled out over time. Then set the piece down. Ring shank holds tight.

Step 6 make a 10 degree bend on the shingle edge of the flashing approximately 1 2 inch from the edge. Fasten loose nails and cover exposed nail heads with roofing cement. Use the metal break tool to bend the flashing lengthwise in the middle according to the angle of the roof joint. It s much easier to reseal the flashing than it is to patch a water stained wall or ceiling.